Minnesota Classic Glastron Forum
General Category => General Discussion => Topic started by: Shorty_GT-150 on October 14, 2010, 03:55:22 PM
-
Well, it won't tow a full scale boat, but maybe a matching 1:4 Scale Intimidator??
This car is huge!! (1:4 scale).... and a 23cc Zenoah engine.... thing is crazy fast....
I need to find or make a 1:4 scale truck body to match my 81 Chev Shortbox.... then I want to make a 1:4 Scale INTIMIDATOR!!!!!
Anyone good at carving styrofoam? or have the stuff to do it?
Should be able to use carved foam as a mold for layin the fiberglass over.....???
Could make a truck body for the kit, And could make a scale Intimidator....
Something to hold me over till the next boat :)
-
Shorty
I think I've seen electric carving knives used for this sort of thing. Doesnt work too good on contours though.
-
Shorty,
Check out MolzerMoweryRacing.com
They are in St Louis Park. I think you'll be suprised!
-
Jason just some thoughts:
Just spent two days carving foam for theatrical stage props. Full-size castle with gargoyles. Mad they will cover all my work with drywall mud mixed with different color latex paint. The end result will be a real looking castile made of stone.
Have run foam threw hot blade to make the shape of the long- easy kit airplane that was covered with fiberglass over the foam wing.
Hot Knife is the way to go. The problem chrome wire or ribbon you can find. A large amperage variable transformer is vary expensive. Low voltage so you do not die. An old 12 volt battery charger if it has full variable amperage works, the problem battery chargers now days will have 2 or 3 settings. You need variable depending on the size of wire (the ohms it draws on a meter), increase the amps until it glows red and will cut foam like a pro.
You need reality. I can show you a small hot knife I made from a soldering iron. Pink foam can be carved with a dermal or real router if variable speed allows for slow. If fast the heat cuts you need slow.
The castle I just made was pink foam run threw my table saw, high speed regular blade hot cut, regular jigsaw cut slow curves for arches like the castle entrance gate just fine. I was cutting pink foam foal size like building from wood.
Small scale fancy or interact caving I?m no artist. I can show you my hot knife. But if you have that remote car, model people have to have some small scale tools or advice on what works.