Recent Posts

Pages: 1 ... 8 9 [10]
91
Classified / Wanted to Buy / Re: Wanted: CVX 20 Sprint
« Last post by Hyperacme on January 15, 2019, 11:22:24 PM »
Welcome to the forum !
Watch the GCOTD thread.
92
General Discussion / Re: Congress Passes New Engine Cutoff Switch Requirement
« Last post by Plugcheck on January 15, 2019, 09:26:58 PM »
I'm surprised only by this not being a requirement before.  Probably rusty in my conversion, but 115 lbs thrust pretty much includes any gas/diesel engine over 2hp.
93
Classified / Wanted to Buy / Wanted: CVX 20 Sprint
« Last post by djfiorani on January 15, 2019, 08:24:14 PM »
I am looking for a CVX 20 Sprint in reasonable condition. Not looking for a complete project boat but looking for something that is in decent shape up to complete restores. Cash buyer in Michigan.
95
Classified / Wanted to Buy / Re: GCOTD
« Last post by Hyperacme on January 15, 2019, 06:22:29 PM »
More pictures
96
Classified / Wanted to Buy / Re: GCOTD
« Last post by Hyperacme on January 15, 2019, 06:20:47 PM »
1971 Glastron GT-150 Restored + Mercury 75HP + New Trailer - $3795 (Londonderry)
https://nh.craigslist.org/boa/d/londonderry-1971-glastron-gt-150/6795235593.html

Well, I hate to do it, but I am going to sell my restored 1971 GT-150 and 1999 Mercury 75HP as I am moving to Florida. If you have any questions or interest, feel free to ask away.

1971 GT150 restored last year. Transom, stringers, floor, interior. All new wiring, gauges, fixtures. The boat is ready to go for anyone looking for a small speed boat. Check out my photos>albums>GT-150 Restoration Photos.

1999 2 Stroke Merc 75hp. Merc Dealer Serviced this year, no issues. New cables, steering. Value $2400

Brand new EZ trailer worth $1000

Asking $3795.00. Motor and trailer are alone worth about that. Located in Londonderry, NH
97
Classified / Wanted to Buy / Re: GCOTD
« Last post by Hyperacme on January 15, 2019, 06:07:03 PM »
1978 Glastron CVX 16 - $2950 (Gallatin)
https://nashville.craigslist.org/boa/d/gallatin-1978-glastron-cvx-16/6793906018.html

Redone classic Carlson. Add two new Douglas fur stringers, transom knee brace. Original factory single keel stringer solid as well as transom. Installed new marine grade plywood floor, woven vinyl carpet, new seats. All wiring reworked, gages installed teak dash, new comming cushions, has original windshield.
Period correct 1980 Merc 150 HP mtr with new modules, rblt carbs, fuel pump, water pump and new spark plugs.
Compression on all cyl 115#.
Trailer in good shape, good tires, whl bearings, working lites. Fuel tank needs flushing.
Motor been in storage for 10 yrs, boat been stored inside for last 17 yrs.
Consider trades for 20-24ft center console and I will pay difference.
98
Classified / Wanted to Buy / Re: GCOTD
« Last post by Hyperacme on January 15, 2019, 05:34:07 PM »
1987 GLASTRON CARLSON CVX16 - $4500 (PORT JEFF)
https://newyork.craigslist.org/lgi/boa/d/1987-glastron-carlson-cvx16/6793507567.html

Solid, clean and fast, turn key operation. Selling due to relocation. Hull and transom solid. Trailer solid. Fell free to ask questions.
99
General Discussion / Re: Composite Transom, stringers, floor, etc
« Last post by fireman24mn on January 15, 2019, 01:17:01 PM »
http://www.spaceagesynthetics.com/

yes Jason you can

In looking around the internet it looks like the sheets are $200- 600 each depending on thickness you get.
100
General Discussion / Re: Composite Transom, stringers, floor, etc
« Last post by Jason on January 15, 2019, 12:13:13 PM »
Can you use this on for the transom as well?
Pages: 1 ... 8 9 [10]