Minnesota Classic Glastron Forum
General Category => Classified / Wanted to Buy => Topic started by: JJ 1983 CV23 on July 22, 2020, 12:18:42 PM
-
Loking for the plastic clips that lock the ladder in the UP position at the hinge.
Also looking for any of the mounts that mount the aluminum poles to the hull.
-
The ladder i picked up a few months ago off a later model (87-88) cv23 needed some work. Mine doesn't have the plastic keeper clip, the swing step just raises up then drops down into a groove. As for the bases just look for round 60 degree. I just bought 4 new ones in stainless. Here are the ones i bought... Ebay number.......383553359915
Link added ..
NEW Rail Fitting 7/8" 60 Degree Round Base (SSFB66040) Boat/Marine ..
https://www.ebay.com/itm/NEW-Rail-Fitting-7-8-60-Degree-Round-Base-SSFB66040-Boat-Marine/383553359915?hash=item594d8fd02b:g:SJYAAOSwn7ZexCva
Sent from my SM-G950U using Tapatalk
-
Id hold off on ordering 4 if the fittings i listed earlier. I tried installing mine today and the angles are not working correctly. I'll report back when i figure it out
Sent from my SM-G950U using Tapatalk
-
Could you tweak the ladder with a conduit bender to match or consider plastic/Teflon/aluminum spacers the correct the angle to fit?
-
Looks to be about 55deg.
(https://uploads.tapatalk-cdn.com/20200725/3a12b8c4d117218d6996ccefc4485c13.jpg)
(https://uploads.tapatalk-cdn.com/20200725/c82ab421d63cf6160f8d12c58e300336.jpg)
-
I bought 2 from West Marine. The angle is correct but the bottom 'center' hole is off by at least 3/8" off center from the original.
Still looking for the plastic clips that hold the ladder up.
Also, can anyone direct me to a video or give me some help as to how to fill the holes in the hull so that I can drill new ones.
-
Can you post a picture of your ladder? I am very curious about the clips as I have not seen one with them.
-
Can you post a picture of your ladder? I am very curious about the clips as I have not seen one with them.
The clips they are talking about are the ones Dave had someone make several year back.
-
The clips they are talking about are the ones Dave had someone make several year back.
and honestly...should be able to 3D print them now.
-
Made batches of these clips back in 2008 to fix the broken ones that came with the 1987 CVX-16. Wish I had made more. Machined from nylon block that required about 5 cuts.