Minnesota Classic Glastron Forum
General Category => General Discussion => Topic started by: 74 Carlson the II on September 28, 2020, 12:43:07 PM
-
Thanks to Mr. Jim Barret and Bill I will have a cv23 hull soon. The plan is to cut out the pad from the 23 and install it on my cv19. Hopefully it works out.
-
Wow! Can’t wait to see this!
-
Why hack up a hull to make scrap when adding a pad is simple work to cut in and fill the area? It is much harder to fit a section from one hull than to just use fresh material.
-
Cause the 23 is already scrap, completely stripped and has nothing in it. Much rather use a factory pad, they designed it better than I could.
-
it will be much easier to graft it in than to make my own.