Minnesota Classic Glastron Forum

General Category => General Discussion => Topic started by: Jason on August 24, 2017, 07:05:16 AM

Title: Glastron Trailer Fenders
Post by: Jason on August 24, 2017, 07:05:16 AM

I want to get two of my trailer fenders reproduced on the CV23. Was also going to try and figure out a way to strengthen them. If anyone knows any custom sheet metal shops please let me know. I always assumed they were the same between all Glastron trailers but maybe not. Group buy??

Title: Re: Glastron Trailer Fenders
Post by: Rosscoe on September 03, 2017, 08:38:02 PM

One way to make them stronger might be to make them one piece? It's one of the few things I like about my trailer. You can walk the entire length. Unless you want to keep it stock.

Title: Re: Glastron Trailer Fenders
Post by: Jason on September 03, 2017, 10:21:50 PM

I like the stock look.

Title: Re: Glastron Trailer Fenders
Post by: Plugcheck on September 04, 2017, 08:25:24 AM

Take a look around here Jason, http://www.trailer-fenders.com (http://www.trailer-fenders.com).    They have a variety of smooth aluminum fenders approximately $50-60 dollar price range.  Cut the inside relief leaving some tabs to attach the plywood/carpet "bumpers".    Otherwise maybe a local trailer shop would take on the work, but I would expect that to be expensive.  BTW, they are only riveted in place with 1/4" buck rivets.  I found the tool for my impact and the rivets on eBay.