General Category > Vendor and Repair Resources

CV23 table

(1/2) > >>

Jason:
A few people have asked me about this in the past. Measures 14.5 x 29 overall. Made from 3/4” plywood with 3/4 x 1-1/8 L trim on the sides. Held together with SS screws on the sides.

carlsoncvx18:
Thanks Jason for the info.

Plugcheck:
Looks like a toon table, did 23's come with such a table or is it an aftermarket peice?  Either way, pretty neat looking table.    I assume it's centered on the back bench area?

Jason:
Yes, sits behind the passenger seat so you can spin that chair around and both front and rear seats can use the table. It's factory as most CV23's seem to have the hole in the floor to mount it. I'll try and get some dims on the pole length as well. Also fits nicely in the side compartment under then port side engine cover.

Jason:
Picture of it in use.

Navigation

[0] Message Index

[#] Next page