Minnesota Classic Glastron Forum
General Category => Classified / Wanted to Buy => Topic started by: thedeuceman on August 23, 2018, 12:33:08 PM
-
i need to reproduce one of these for someone cuz the aftermarket ones don't fit just right.
i can make 1 out of stainless manually but...
Im gonna put this out there to see if there is any interest.
we could code it for the CNC and make a few @ $20 each (proceeds all go to the machinist)
so i have 2 questions
1, are the 2 latches the same or are they mirror image? (in regard to the counter sunk mounting holes)
pay no attention to the 2 extra holes drilled in the unit
2, is the slot actually 5/16 wide?
we could make them with no holes or with 4 symmetrical holes
they will be machined from 316 stainless, sharp edges broke and parts will be passivated to prevent rust.
thanks
Joe
-
(https://uploads.tapatalk-cdn.com/20180823/d076bec0533e7d5be73447545dc74eb2.jpg)
Sent from my iPhone using Tapatalk Pro
-
I should also mention, if the quantity goes up price will come down
Sent from my iPhone using Tapatalk Pro
-
I don't need one but I can get some measurements for you.
-
Stop by and look at mine if you need measurements or if you need to pull it and bring it to work thats fine. I won't be using the boat till next weekend.
-
They do not use counter sunk bolts
-
Yes. 5/16 wide.
(https://uploads.tapatalk-cdn.com/20180825/791457b07853bffff80f8841c1e95cfc.jpg)
-
(https://uploads.tapatalk-cdn.com/20180825/246deb019d7ea2a741a190605cdc099e.jpg)