Welcome,
Guest
. Please
login
or
register
.
Did you miss your
activation email
?
1 Hour
1 Day
1 Week
1 Month
Forever
Login with username, password and session length
Home
Help
Login
Register
Minnesota Classic Glastron Forum
»
General Category
»
General Discussion
»
Attwood stern light components into a stock mount?
« previous
next »
Print
Pages: [
1
]
Author
Topic: Attwood stern light components into a stock mount? (Read 1855 times)
0 Members and 1 Guest are viewing this topic.
demian5
Sr. Member
Posts: 323
Work hard and use your vacation days...
Attwood stern light components into a stock mount?
«
on:
August 27, 2019, 05:18:28 PM »
Anyone put the parts out of an Attwood stern light into a factory base to get it working? I have heard legend of this being able to be done, but would like to hear from someone. Id neeed to swap the receptacle and the swivel cover.
Thanks in advance.
Logged
1979 Glastron Carlson CVX 16 SS I/O Mercruiser 140 "Brick House"
Diamond Chad
Administrator
Hero Member
Posts: 524
Re: Attwood stern light components into a stock mount?
«
Reply #1 on:
August 28, 2019, 09:02:36 AM »
I had crumby short wires on my 87. I purchased a new base at West Marine (don't know if it was attwood, probably was), and the plastic connector part swapped right into my old base. It was a perfect fit.
Logged
2012 GTR 160 Collectors Edition
87 CVX-18 5.7 (Sold)
88 CVX-16 115 Merc (Sold)
57 Dunphy Imperial Musky - 57 Golden Javelin
01 Malibu Sunsetter 21 LSV 340 EFI
demian5
Sr. Member
Posts: 323
Work hard and use your vacation days...
Re: Attwood stern light components into a stock mount?
«
Reply #2 on:
August 28, 2019, 10:28:37 AM »
I had to do a little trimming of the plastic insert under the top shoulder and it fit good. Nice and tight. The screw to get the flip cover off the attwood was tight and had to use vice grips to get off after almost stripping the Phillips head.
Logged
1979 Glastron Carlson CVX 16 SS I/O Mercruiser 140 "Brick House"
Villager19
Full Member
Posts: 97
Re: Attwood stern light components into a stock mount?
«
Reply #3 on:
September 28, 2019, 04:22:02 PM »
This one worked on my CVX-18 with no modification or trimming at all. I just pushed the old plastic insert out from the bottom. The plastic insert from the Attwood light base fit right in there.
Logged
Illinois Dave
1979 Glastron Carlson CVX-18
2014 Crownline 215 SS
Villager19
Full Member
Posts: 97
Re: Attwood stern light components into a stock mount?
«
Reply #4 on:
September 28, 2019, 04:25:15 PM »
LOL. The last photo makes it look like the Attwood insert does not fit. That was meant to be an "action shot" of how to replace just the plastic inaert.
The black plastic insert fits completely flush without any modifications.
Logged
Illinois Dave
1979 Glastron Carlson CVX-18
2014 Crownline 215 SS
Print
Pages: [
1
]
« previous
next »
Minnesota Classic Glastron Forum
»
General Category
»
General Discussion
»
Attwood stern light components into a stock mount?