General Category > General Discussion
MC1 trim cylinder reseal
(1/1)
demian5:
I bought the quicksilver kits.
The trim cylinders worked fine but one started leaking at the shaft after I manually lifted the drive after it had drooped down a little. Figured I should do both.
Is it a simple task?
75starflight:
It isn't too bad of a job. The hardest part is getting the orifice out at the end of the cylinder if it doesn't come out when you remove the ram.
I did both of mine on my v179 in an afternoon.
Navigation
[0] Message Index
Go to full version