General Category > Vendor and Repair Resources
Glastron / Carlson Steering Wheels
Terry_Curran:
Here’s one of my ‘86 SSV-191
EDIT ..
1986 SSV191 from brochure
Hyperacme:
A old square shaft wheel can be converted to a keyed/taper shaft wheel.
Some options .. Thanks Ray !
There’s a few options: you could just use a different wheel entirely. Detmar made the later style wheels and made several hub styles, but they all relied on a 3 screw system to hold the spikes to the hub. Some hubs had interchangeable adapters. A little use of some plate and you can modify your old wheel to use the new style adapter. Lots of possibilities.
The adapter you posted (first picture) above is what I would do if I didn’t have all these parts. I’d place that inside of the old plastic hub, drill and tap where needed, and the only other mod you would have to do is make the G center cap removable. Adhesive backed strong magnets would be perfect.
cv-19:
Ride Guide rack cable installation info.
cv-19:
CV-19 original ride guide steering cable length. 17ft. 6 in.
Cables are marked close to cable end. Can use 18 ft. cable,
but will have to loop it at the engine end.
oskar-lima:
Thank you, Gregg, for this fantastic overview of steering wheels :D
This is the one I have in our '80 SSV-164.
Greetings from Germany,
Oliver
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version