General Category > General Discussion

aq270/130c switch on top of tilt trim

(1/2) > >>

melinprov:
So, I have verified all the wiring and have the new relays, but I still am having a tuff time figuring out this switch/circuit breaker that was on the top of the tilt trim it is mostly broken and has the red tape on top here. The switch is made of blue plastic with a wire from 86/3 (com) on the relay and from the bottom of the switch on the same relay that is between 30/51 and 87/87a

melinprov:
this is the diagram showing those wires

melinprov:
this is what's left of the original part

melinprov:
this is what I think this part is based on the wire diagram, this part is from a newer tilt trim I am not sure how the old one (mine) measured the up of the thrust rod if this is what it is. I do not recall any protrusion from it-however it was directly over the center of the thrust rod. The diagram says 7 circuit breaker. Any electric guys out there. Would the way this is wired allow the switch to sense position through its connections...and... does anyone know what kind of switch/circuit breaker or part number I should use?

melinprov:
it was bolted on over the heat protection device seen here

Navigation

[0] Message Index

[#] Next page