Minnesota Classic Glastron Forum

General Category => Classified / Wanted to Buy => Topic started by: thedeuceman on August 13, 2021, 01:43:02 PM

Title: Lessons learned High pr trim pump
Post by: thedeuceman on August 13, 2021, 01:43:02 PM

Does anyone have a high-pressure trim pump I could buy or borrow before the meet, preferably by tomorrow ?
(https://uploads.tapatalk-cdn.com/20210813/6d5b49a394addca4da00645bea9b5985.jpg)


Sent from my iPhone using Tapatalk Pro

Title: Re: Lessons learned High pr trim pump
Post by: nes-cv23 on August 13, 2021, 06:40:54 PM

How about this? 

Title: Re: Lessons learned High pr trim pump
Post by: thedeuceman on August 13, 2021, 08:06:26 PM

Thanks, I have one like Brian pictured, it’s got 3/16 lines on it but fortunately Oriley had two adapters in stock
(https://uploads.tapatalk-cdn.com/20210814/f4c8ab12ae91b29b1fc822dbb00aab77.jpg)


Sent from my iPhone using Tapatalk Pro

Title: Re: Lessons learned High pr trim pump
Post by: thedeuceman on August 14, 2021, 11:16:27 AM

Before I swap the pump out I did some checking, hydraulic lines were on backwards when we installed it it wasn’t working right so I thought that was the issue turns out it had been wired backwards in two places and I fixed one while sorting out the wiring under the console. I used a lifting scale and a couple chains connected to Outdrive to the trailer, ran it up and it would stop moving at 600 pounds. Swapped the pump wires and the lines, the scale pegged at 2000 and it was still trying to lift.


Sent from my iPhone using Tapatalk Pro