Minnesota Classic Glastron Forum
General Category => General Discussion => Topic started by: Onger on September 26, 2020, 06:16:18 PM
-
I'm terrible at computers . Hopefully I'm doing this right .
Can I remove the floatation boxes on my cvx 18 so I have room to work on my motor ? Are they structural? I'd way rather have room to work on the motor . Make some kind of removable floatation. Has anyone done this ? Would appreciate any info . Thanks
-
Most of us pull them out for exactly the same reason...storage and room to access the motor.
-
I removed mine for the extra space.
When I go to restore mine I will be putting them back in just lower..
-
I did not replace the flotation foam boxes on my CVZ-18, though I will on my intimidator. The difference being the top openings. Have considered making removable blocks in the CVZ for engine access, but still in design phase.
-
Welcome to the forum Onger !
Reason for foam boxes below.
Another option would be remove boxes and foam under floor.
Might not give "Level floatation" though ...