Evinrude 85 parts and fuel tank, cleaning house (garage actually)

[thedeuceman]

motor on the left must go, free for the taking
im keeping all the electrical and the carbs, it has low comp on 2 cyl, does not have power tilt/trim.
Doug Campbell asked for the block a while back, have not heard if he still wants it.

other 2 motors are for sale, 1966 80 runs w good comp but needs wiring $125
the one in the middle is a 62 or 63 33hp, got it from a friend. on the off chance that someone here wants it they could prob use some $$ so i can check it out if requires

i also have a transom bracket from a mercruiser 140, free to anyone who can use it

alum fuel tank from a cobalt, 48 1/2 x 21 at top, 18 at bot, 7 1/4 tall, free
i also have a set of io gauges and a morse helm/cable with a cool looking retro wheel listed here, also free for the taking.

[dorelse]

Hey Joe, I'll take the fuel tank if you're willing to hang on to it for a bit...if my existing tank continues to be an issue, that will fit nicely under the bench seat.

I'll be up for the boat show in January, and likely a ski trip over Christmas break to Afton Alps.

[thedeuceman]

sounds good, ill tape up the fittings and stash it next to the garage.

[Terry_Curran]

I believe I just saw a post where Doug was asking about that block of yours.  Have you tried to send him a message?

Terry

[thedeuceman]

Not yet, but i will before it goes anywhere else.

[Rosscoe]

Joe
What kind of wiring issues are there on the 66 80hp? That would look good on the back of my 61 Surflite.
Have you ever had it running?

[thedeuceman]

Insulation is all rotten.
I hot wired it, and bypassed the fuel inlet cuz it was plugged
Any it started right up, I only ran it for about 30 sec cuz I had no cooling water to it.
I have the control but the cable is bad.

[thedeuceman]

Ross, i sent more pix

[thedeuceman]

more pix of the 66

[thedeuceman]

and closer pix of the outside of the 85hp

[thedeuceman]

this mid section is going to scrap in a week or so if no one can use it.