General Category > Vendor and Repair Resources
CV23 Hatch Cover & Latch Bracket
(1/1)
Jason:
Does not come with holes drilled for hardware.
$300+shipping as of time of this posting
(248) 437-4440
E-Mail: info@edsplastics.com
dorelse:
Red had a mold made from Barb's CV-23...I though Eaton Quade had the master?
http://www.eatonquade.com/
Kinda looks like a Glastron dash reproduction too:
CVX Fever:
--- Quote ---Kinda looks like a Glastron dash reproduction too:
--- End quote ---
Think Barb had a dash made for the Intimidator that would accept the newer larger diameter gages.
Burnin Daylight:
We did not make a mold for the CV23 hatch cover, but that is the mold for the new instrument panel for an Intimidator and CVX20 that will accommodate the newer larger gauges.
Hyperacme:
Lower bracket for the hatch latch. Thanks Tim C.
Here ..
https://www.fisheriessupply.com/vents-fans-hatches-and-windows/hatch-hardware
And here …
https://m.go2marine.com/controller?f=22487F&catPath=All+Products%2Fc_Hinges%2C+Latches+and+Pulls
Navigation
[0] Message Index
Go to full version