Minnesota Classic Glastron Forum
General Category => General Discussion => Topic started by: demian5 on September 21, 2018, 06:14:58 PM
-
MC-1 I have steering play is in my Gimble ring I believe. I see all kinds of stuff about repairing these for Alpha drives but little for these MC1 drives or "pre-alphas". Anyone have experience? I will have the motor out so that won't be an issue.
I tried to tighten the pinch bolt on the steering arm from the inside of the boat, but it was tight. AND I don't think there was a nut or anything on top of the pin to tighten.
Thanks in advance!
-
The problem is wear and play forms where the pinion pin goes through the upper part of the gimbal.
-
Where can I get a replacement pin and gimble ring?
-
I got nos parts on ebay when I did mine. Pain to ger upper nut off. Need to drill holes in transom plate.
Gimbal Ring
https://r.tapatalk.com/shareLink?share_fid=82420&share_tid=4651&url=http%3A%2F%2Fforum%2Ecgoamn%2Ecom%2Findex%2Ephp%3Ftopic%3D4651&share_type=t
-
I dont think there is a nut on top of the pin in the gimble housing...
-
I will have the motor out, will this make changing the gimbal ring easier?
Also, what model square gimbal rings will interchange with the splined gimbal ring on my 1979 mercruiser 140?