Minnesota Classic Glastron Forum
General Category => General Discussion => Topic started by: Hyperacme on July 21, 2020, 09:46:52 PM
-
Brough the CV to BBW for estimate on hull repair.
After poking around, found it was cracked (about two feet) on the right inner chine / stake and also cracked (about two feet) on the keel.
The friendly staff at Barrett Boat Works estimated repair would take about a week.
Thanks Jimmy & Dave !
-
oh man!
-
Only one week turnaround. You must have had some clout.
-
Blast from the past !
From transom repair in 2013
Great progress !
-
From the folks at BBW's ..
Gallon and a half of Resin, $78.00.
Cab and glass sheet from Express Composites, $25.00.
David and my expertise, priceless!
-
Nicely done, super impressed by the turn around time
-
Have heard nothing but great things about Barrett boat works...
You get all three
Hi quality
Fast turn around time
Low cost
But as well-known with these guys their practices and procedures are top-secret so they only show one picture of the finished work
Sent from my iPhone using Tapatalk Pro
-
Have heard nothing but great things about Barrett boat works...
You get all three
Hi quality
Fast turn around time
Low cost
But as well-known with these guys their practices and procedures are top-secret so they only show one picture of the finished work
Sent from my iPhone using Tapatalk Pro
Oops
They let out their secrets, I guess I didn’t scroll up
Sent from my iPhone using Tapatalk Pro
-
After working day and night, with only a quick 15 minute break .. Boat is done !
Barrett Boat Works is the BEST !
Thanks Jimmy & Dave !
-
Gregg - I'm guessing your boat was taking on water which is why you cut the floor out?
Now..... if you don't already, put an automatic bilge pump in that CV16.
Good Job Barrett Boat works!!!!!!
-
It has full coverage insurance .. It's worth more if it sinks .. :o
J/K .. it's on the "To Do" list.
-
;D I think that's one instance where you wouldn't want a check. I know I'd be upset and mine doesn't look near as good as yours does
-
Ready to roll !
-
Holds beer and doubles as a seat, time to get boat wet!
-
Y'know ya cain't keep nickel and dime'n that pos forever ...
-
I can't afford a nice boat Doug .. :'(
-
Have heard nothing but great things about Barrett boat works...
You get all three
Hi quality. Fast turn around time. Low cost
Sent from my iPhone using Tapatalk Pro
We have learned from the best! Thanks Joe & Jeff
-
She's home and washed, drip drying now Jim ..
-
Git'r done! I wanna see that boat screaming with the crowd as I watch the meet "virtually" :(
Looking good Gregg!!!
-
Wow! Very nice.
-
Got the carpet in today .. Seats tomorrow.
-
Looking good!
-
Little more progress
-
Nice!
-
Driver seat almost in ..
-
That's all you need, plenty of room for a big cooler and let's go! Ha
-
Turn it into a single seater !
-
Gregg, you know that boat inside and out. Good work.
-
Looks great. It looks like u put carpet on the bow knee board below the deck? Do you do anything to the transom? Beyond applying the resin? Boat looks fantastic.
-
Replaced transom seven years ago ..
http://forum.cgoamn.com/index.php?topic=4062.0
-
Its been 7 years since you did the transom! Time sure goes by fast.
I look at pictures of when I put the transom in Phoenix and I can't believe it has bee almost 10 years since then!
-
Not sure who wrote this when we did transom.
-
Seats and other junk installed ..
Tomorrow motor .. hope it starts .. LOL
-
Beautiful boat, can't wait to see it next week.
-
It should be river ready - let it run!!!!!!!!!!!!!!
-
She fired off on second try !
So .. I gave her a much needed bath ..
-
Great to hear that she’s a runner.
-
just in time!
Sent from my iPhone using Tapatalk