General Category > General Discussion

CV16SS Transom Replacement

<< < (2/2)

Joebergen355:
Thanks for the info, I will be using marine ply. The Coosa is my preferred option but I have a few other things under way that I don't want to take the funds away from

Joebergen355:
Well once i got into it the transom was much worse than i anticipated, was really only "solid" where i was able to check it and much if that was due to some epoxy patches from a previous owner (I just got the boat in early September). I also uncovered how poorly the floor was done aswell so i will now be doing the transom, floor, and stringer.

I will continue with the cap on. Just like @thedeuceman s V8, its glassed over and is not a thread i feel the need to pull at

Joebergen355:
All the wood is now removed and grinding is starting. The previous owner did the floor up to the ski locker with AC-X plywood, once removed i found an additional layer of 1708 covering the stringer. At first, i was worried that it was also a repair for cracks on the chines but it was hardly wet down with resin (still cloth like in places) and once removed the chines look to be solid.

The stringer tabbing is broken about half way up so if i decide to pour the stringer, a mold will be needed.

Navigation

[0] Message Index

[*] Previous page