Minnesota Classic Glastron Forum
General Category => Classified / Wanted to Buy => Topic started by: demian5 on September 24, 2018, 12:45:03 PM
-
Hi all -
Im looking for the following or ideas on what to get:
A good voltage gauge. Mine reads 16v key on, and pegged when charging. I kn ow its putting out the right voltage as I have measured it with my DVOM, would like a gauge that is within range.
New vents grills for the side, also is there supposed to be some kind of assembly or air box that routes the bilge vent hoses op to the vents themselves?
Good used gimble ring for MC1. I hear the pin rarely wears and its usually the gimble ring, if not, i need a good PIN too.
Trim limit switch. Ill have the gimble out so this would be the time to replace it. Might as well put a trim gauge in too, so if someone has a good used set...
Hoses for the trim between the pump and the bottom of the transom, can I get new ones?
Thanks!