Minnesota Classic Glastron Forum

General Category => General Discussion => Topic started by: 74 Carlson the II on September 28, 2020, 12:43:07 PM

Title: Cvx23 hull
Post by: 74 Carlson the II on September 28, 2020, 12:43:07 PM
Thanks to Mr. Jim Barret and Bill I will have a cv23 hull soon. The plan is to cut out the pad from the 23 and install it on my cv19. Hopefully it works out.
Title: Re: Cvx23 hull
Post by: Jason on September 28, 2020, 02:02:18 PM
Wow! Canít wait to see this!
Title: Re: Cvx23 hull
Post by: CharlieN on October 17, 2020, 04:40:21 AM
Why hack up a hull to make scrap when adding a pad is simple work to cut in and fill the area? It is much harder to fit a section from one hull than to just use fresh material.
Title: Re: Cvx23 hull
Post by: 74 Carlson the II on October 18, 2020, 01:55:27 PM
Cause the 23 is already scrap, completely stripped and has nothing in it. Much rather use a factory pad, they designed it better than I could.
Title: Re: Cvx23 hull
Post by: 74 Carlson the II on October 18, 2020, 01:58:13 PM
it will be much easier to graft it in than to make my own.