Minnesota Classic Glastron Forum
General Category => Vendor and Repair Resources => Topic started by: Jason on July 02, 2013, 11:03:35 PM
-
Does not come with holes drilled for hardware.
$300+shipping as of time of this posting
(248) 437-4440
E-Mail: info@edsplastics.com
(http://i159.photobucket.com/albums/t124/lincolnman1969/misc/hatchcover7-2-13004_zps0b40eb2a.jpg) (http://s159.photobucket.com/user/lincolnman1969/media/misc/hatchcover7-2-13004_zps0b40eb2a.jpg.html)
-
Red had a mold made from Barb's CV-23...I though Eaton Quade had the master?
http://www.eatonquade.com/ (http://www.eatonquade.com/)
Kinda looks like a Glastron dash reproduction too:
(http://www.eatonquade.com/photos/full/ffrankie.jpg)
-
Kinda looks like a Glastron dash reproduction too:
Think Barb had a dash made for the Intimidator that would accept the newer larger diameter gages.
-
We did not make a mold for the CV23 hatch cover, but that is the mold for the new instrument panel for an Intimidator and CVX20 that will accommodate the newer larger gauges.
-
Lower bracket for the hatch latch. Thanks Tim C.
Here ..
https://www.fisheriessupply.com/vents-fans-hatches-and-windows/hatch-hardware (https://www.fisheriessupply.com/vents-fans-hatches-and-windows/hatch-hardware)
And here …
https://m.go2marine.com/controller?f=22487F&catPath=All+Products%2Fc_Hinges%2C+Latches+and+Pulls (https://m.go2marine.com/controller?f=22487F&catPath=All+Products%2Fc_Hinges%2C+Latches+and+Pulls)