General Category > Classified / Wanted to Buy

boarding ladder for 85 intimidator

<< < (3/3)

Carlson_from_Germany:
If I was gonna do a full resto on a boat again I’d go ahead and get this one. A friend has it on his CVX16. I know it’s all in German but you guys should have Osculati in the states as well I’d assume. Check out the pictures how it’s stowed.

https://www.ebay.de/itm/163334971493?chn=ps&var=462606204727&norover=1&mkevt=1&mkrid=707-134425-41852-0&mkcid=2&itemid=462606204727_163334971493&targetid=1297988891644&device=m&mktype=pla&googleloc=9043568&poi=&campaignid=10203814722&mkgroupid=121830191745&rlsatarget=pla-1297988891644&abcId=1145990&merchantid=7546522&gclid=Cj0KCQjwk4yGBhDQARIsACGfAetRWAhMUc7R8b2MsRtGg_X-b4p_H_m-SXwbUD9TeVPca1kr1ZSZscwaAjuFEALw_wcB

Terry_Curran:

--- Quote from: Jeff Siebert on June 10, 2021, 11:00:18 PM ---Does the ladder sit okay on the deck top when folded?  I was looking at those but was trying to find something close to original. It is getting harder to get back in the boat without a ladder. My other option was to get younger.

--- End quote ---
As you can see, the po moved the grab bar to the rear and used a Velcro strap to secure it to the bar. I will add, the bar makes it easier  to climb back into the boat

thedeuceman:

This ladder here was used by Glastron in the early 90s, shown attached to our GT150. The 91 1900, and 92 16CSS both have the same ladder. As the design of that part of the hull is nearly the same on all these sporty Glastron Carlsons I think this ladder would be a good choice, unfortunately they are a little hard to find and I’m not willing to part with the one I have. It’s nice and compact, looks decent, it doesn’t hang down as far as one might like, but being old and overweight I can still get in all of our boats with this unit.


Sent from my iPhone using Tapatalk Pro

Terry_Curran:
Btw, the po had a plasma table and cut, I believe, 1/2” stainless supports to thread bolts into for strength against the fiberglass  And I can tell you that with the motor in, it’s very difficult to do by yourself, not impossible. The blocks I believe were about 1 1/2” by about 4”? 

Navigation

[0] Message Index

[*] Previous page