Minnesota Classic Glastron Forum
General Category => Classified / Wanted to Buy => Topic started by: thedeuceman on August 21, 2012, 01:34:59 PM
-
i picked this motor up a while ago thinking i could use it on my GT-150, but its too small and dont have tilt/trim
i bought it not knowing if it ran, checked comp, 75 to 80 in all 4 cly.
fuel inlet was plugged so i bypassed it, filed the points, hotwired it...
started and ran nice, good idle, only ran for 30 seconds because my muffs would not fit it, but i can fix that for "show and tell"
the insulation is rotted off all the wiring on the motor, i have the control and harness also.
i have it listed on CL for $250 (yea kinda hi)
sell to a member that could use it for $150 or ??, would like to move it fast
-
Might want to consider putting it in the "Glassifieds" (free) over on FG, Joe. There's always somebody there looking for a "period correct" motor, and 80hp would be considered plenty! :D
(If no one here needs it, of course!)