General Category > Classified / Wanted to Buy
WINDSHIELD HELP
jnich24:
Can someone give me advice of the easiest wat to remove the windshield frame for a 73 cv-16? I am getting my butt kicked by it.
Thanks to all
John
Hyperacme:
There are small clips that hold windshield into aluminum frame.
I have never done it .. but you will need to "carefully" spread aluminum frame apart to get clips out of channel of frame.
Picture below is best I could find ..
The ones used on your windshield don't have the nut welded to them, but have a sharp "tooth" that would dig into windshield plexiglass
jnich24:
Thanks Hyperacme...I got it done. I had to make several thin shims to wedge in between the small tabs and the windshield finally came out. It was not an easy job for sure. I don't see why a new windshield cannot be placed back in with just windshield adhesive.
Thanks again
Hyperacme:
Could you take a few pictures of clips and post them, I had some pictures and lost them .. :o
You might be able to get a "thicker" GLAZING ASSEMBLY VINYLS to get a tighter fit of plexi wind screen.
https://www.taylormadeproducts.com/hardware/glazing-assembly-vinyls/
jnich24:
Will do...it will be a couple days but I will post them.
Navigation
[0] Message Index
[#] Next page
Go to full version